ASAP A-1
Programmable Energy Saving
Water Heater Timer

EASY INSTALL

Just Follow These Simple Steps:

• Mount the timer in the desired location about three inches (3”) under the electrical sub panel or near the water heater using the three (3) mounting holes which are provided.

• Use the installation wiring diagram on back of front cover to complete wiring.

• The A-1Programmable Energy Saving Water Heater Timer should NEVER be used as a means of disconnect!
• Always turn off the circuit breaker before servicing the water heater.
• It is your responsibility to contact a qualified electrician to install the timer.
  To assure that the electrical installation is adequate and in conformance with the National Electrical Code, ANSI/NFPA 70 – latest edition and all local codes and ordinances. Failure to comply with instructions could result in personal injury and/or property damage!
  
  
• WARNING: DISCONNECT THE POWER SOURCE BEFORE INSTALLING THIS PROGRAMMABLE ENERGY SAVING TIMER.